ISO 9001 quality management system
ISO 9001:2015
Quoting, production, inspection and shipping follow written procedures, audited every year by an independent body. For the buyer, every batch is made under the same traceable system.
Hydraulics and pneumatics
Manifold blocks, spools and cylinder caps, with measured sealing surfaces.
In hydraulic parts, problems usually show up at intersecting holes and sealing faces. We machine manifolds in one 5-axis setup, check every intersection for burrs, and measure seal faces in every batch.
What buyers in this industry ask for
- Burr-free intersections between holes
- Ra and form measurement on sealing faces
- Cleanliness and residue control
- Material certificate (EN 10204 3.1)
Typical parts
- Manifold blocks
- Valve spools
- Cylinder caps and flanges
Processes we use
Case studies
- Hydraulic manifold: from three setups to one
We moved a hydraulic system maker's manifold to a single 5-axis setup; scrap fell from 4.1% to 0.5%.
Parts for this industry
Hydraulic manifold block
Manifold with intersecting angled holes, one 5-axis setup.
- Part size
- 160 × 110 × 80 mm
- Tolerance
- Hole position 0.02 mm
- Batch size
- 400 pcs
Valve spool
Hardened and ground proportional valve spool.
- Part size
- Ø 16 × 120 mm
- Tolerance
- Ø 16 g5, Ra 0.2 µm
- Batch size
- 2,000 pcs
Cylinder end cap
Hydraulic cylinder cap with seal grooves and thread.
- Part size
- Ø 110 × 45 mm
- Tolerance
- Seal groove Ø 80 H8, Ra 0.8 µm
- Batch size
- 800 pcs
Relevant certificates
Have a drawing?
Send it with the quantity you need. We check manufacturability and quote complete drawings within 2 working days.